Care and Cleaning
• Seat pad – Remove from frame. Fasten buckles on seat restraint and seat pad.
Fasten all hook-and-loop patches to the corresponding patch. Machine wash
with cold water, gentle cycle. No bleach. Tumble dry, using low heat.
• Bolster – Machine wash with cold water, gentle cycle. No bleach. Air dry fl at.
• Frame – Wipe the metal frame with soft, clean cloth and mild soap.
FCC Statement / CAN ICES-3 (B) / NMB-3(B)
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
1 this device may not cause harmful interference, and
2 this device must accept any interference received, including interference that may cause undesired operation.
WARNING: Changes or modifi cations to this unit not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit diff erent from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
– 3 –