Tripp-Lite B006-DP2UA2 Guia De Inicio Rapido página 5

Installation
1
Plug your USB keyboard and USB mouse into the USB
console ports in the Console Ports Section located on the
unit's rear panel.
2
Plug your monitors into the DisplayPort console ports in the
Console Ports Section located on the unit's rear panel and
power on the monitors.
3
Plug your microphone and speakers into the Audio Jacks
located on the unit's front panel. Audio cables are required
to connect to the CPU for this connection to work.
4
Plug your secondary microphone and speakers into the
Audio Ports located on the unit's rear panel.
Note: The microphone and speakers plugged into the front panel
have priority over those plugged into these jacks.
5
With a user-supplied DisplayPort cable, plug the
DisplayPort connector into any available DisplayPort port
in the KVM Ports Section of the switch (CPU1, CPU2,
etc.). Then, plug the USB 3.0 cable, microphone cable and
speaker cable into their corresponding ports. With a second
user-supplied DisplayPort cable, plug the DisplayPort
connector into the DisplayPort in the same KVM Ports
Section of the switch.
Note: Verify that all the connectors are in the same KVM Ports
Section (all in CPU1, all in CPU2, etc.).
5