Loading The Ribbon - Sartorius YDP30 Instrucciones De Manejo

3.3 Loading the Ribbon

1. Open the printer's top cover by pulling the top cover open levers located on each
side of the printer and lifting the top cover to the maximum open angle.
2. Open the ribbon access cover.
3. Insert the right side of the ribbon into the supply hub. Align the notches on
the left side and mount the ribbon on the spokes.
4. Stick the ribbon onto the ribbon rewind paper core and insert the paper
core onto the rewind hub.
5. Turn the ribbon rewind gear until the ribbon plastic leader is thoroughly
wound and the black section of the ribbon covers the print head.
Close the ribbon access cover and the top cover.
6. Loading path for ribbon
Setup
Operating Instructions YDP30 11