Descargar Imprimir esta página

Fellowes P-35C Manual Del Usuario página 3

Ocultar thumbs Ver también para P-35C:

Publicidad

OPERATION
Continuous operation:
3-minute maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
3 minutes will trigger
30 minutes cool down period.
Safety Lock prevents accidental operation.
To unlock, slide black button up. For greater safety, always unplug shredder after use.
TROUBLESHOOTING
Paper jam: Set to Off (O), lift head and empty bin. Replace head on bin and follow any or
all of the below procedures.
Set to Reverse (R)
Set to Off (O)
for 2-3 seconds
and unplug
MAINTENANCE
Run regularly in reverse for
one minute
Oil when bin is full, or
immediately, if:
• Capacity decreases
• Motor sounds different, or
Shredder stops running
WARRANTY
LIMITED WARRANTY Fellowes, Inc. ("Fellowes") warrants the cutting blades of the
machine to be free from defects in material and workmanship for 3 years from the
date of purchase by the original consumer. Fellowes warrants all other parts of the
machine to be free of defects in material and workmanship for 1 year from the date
of purchase by the original consumer. If any part is found to be defective during the
warranty period, your sole and exclusive remedy will be repair or replacement, at
Fellowes' option and expense, of the defective part.
This warranty does not apply in cases of abuse, mishandling, or unauthorized repair.
ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR
15
All manuals and user guides at all-guides.com
PAPER
Set to Off (O)
and plug in
CARD
Set to Auto-On (I)
To set, wait for shredding to stop, set control switch to Off (O) position, then slide black button down.
Gently pull uncut paper
from paper entry.
Plug in.
15
Follow oiling procedure below and repeat twice.
*Apply oil across entry
Set to Off (O)
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
Set to Auto-On (I)
Feed into paper entry
and release
Hold card at edge
Set to Reverse (R)
Set to Auto-On (I)
A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE
WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any
consequential or incidental damages attributable to this product.
This warranty gives you specific legal rights. The duration, terms, and conditions of
this warranty are valid worldwide, except where different limitations, restrictions, or
conditions may be required by local law.
For more details or to obtain service under this warranty, please contact us or
your dealer.
Set to Off (O)
and unplug
Feed card into center of
entry and release
Shredder doesn't start:
Make sure switch is in auto position (I).
Make sure safety lock is in unlock position.
Make sure head is on basket correctly.
Check for jam.
Remove and empty basket.
Wait 30 minutes for motor to cool down.
Set to Reverse (R)
Shred one sheet
for 2-3 seconds
15
3

Publicidad

loading