Kobalt TOUGH TOOLS K10D-06AB Manual Del Usuario página 10

oPeraTinG insTruCTions
6. installing bits (sold separately)
a. Unplug the drill from the power source.
b . Lock the trigger switch by placing the direction-of-
rotation selector (D) in the OFF (center) position.
c . Open the chuck (C) jaws by turning the sleeve (A)
in a counterclockwise direction until the opening is
slightly larger than the bit you intend to use. Raise
the front of the drill slightly to keep the bit from falling
out of the chuck (C) jaws.
d . Insert the drill bit into the chuck.
e . Tighten the sleeve by hand.
f. Place the chuck key (F) in one of the three chuck key
holes (B) and tighten in clockwise direction. Repeat
with the remaining two chuck key holes.
WarninG: It is important to tighten the chuck with
all three key holes to prevent slippage.
g. Remove the chuck key.
WarninG: Insert the drill bit straight into the chuck
jaws. Inserting the drill bit into the chuck jaws at an angle
and then tightening the chuck and using the drill could
cause the drill bit to be thrown from the drill, resulting in
possible serious personal injury or damage to the chuck.
7. removing bits
a. Unplug the drill from the power source.
b . Lock the trigger switch (E) by placing the direction-of-
rotation selector (D) in the OFF (center) position.
c . Place the chuck key (F) in one of the three chuck key
holes (B) and loosen the chuck (C) by turning in a
counterclockwise direction.
d . Loosen the sleeve (A) by hand.
e . Remove the drill bit.
f. Remove the chuck key.
6
C
7
C
10
B
A
C
B
A
B
D
E
F
D
F