Operating Instructions - Kobalt TOUGH TOOLS K10D-06AB Manual Del Usuario

oPeraTinG insTruCTions

1. Trigger switch
a. To turn the drill ON, press the trigger switch (E).
b . To turn the drill OFF, release the trigger switch.
noTe: The trigger switch delivers higher speed with
increased trigger pressure and lower speed with
decreased trigger pressure.
2. Lock-on Button
This drill is equipped with a lock-on button (G), which is
convenient for continuous drilling/driving for extended
periods of time.
a. To drill continuously, press and hold the trigger switch
(E) and then press the lock-on button. Release the
trigger switch.
b . To unlock the lock-on button and stop continuous
drilling, press the trigger switch.
3. direction-of-rotation selector
The direction of bit rotation is reversible and is controlled
by a selector located above the trigger switch (E). With
the drill held in the normal operating position, pointing
away from you:
a. Position the direction-of-rotation selector (D) to the
left of the tool for forward rotation.
b . Position the direction-of-rotation selector to the right
of the tool for reverse rotation.
noTe: To prevent gear damage, always allow the drill to
come to a complete stop before changing the direction of
rotation.
noTe: The drill will not run unless the direction-of-
rotation selector is fully engaged to the left or right.
1
2
3
Reverse
E
8
E
G
E
D
D
Forward
E