Publicidad
Idiomas disponibles
Idiomas disponibles
A/C
TAS012112MD
TROUBLESHOOTING TIPS
5. A peculiar smell comes out from the indoor unit.
This is caused by the indoor unit giving off smells permeated from building material, from
furniture, or smoke.
6. The air conditioner turns to FAN only mode from COOL or HEAT mode (For cooling and
heating models only).
When indoor temperature reaches the temperature setting on air conditioner, the compressor
will stop automatically, and the air conditioner turns to FAN only mode. The compressor will
start again when the indoor temperature rises on COOL mode or falls on HEAT mode (For
cooling and heating models only) to the set point.
7. The air conditioner runs Anti-mildew function after turning off the unit.
When turning off the unit under COOL(AUTO COOL, FORCED COOL) and DRY mode, the air
conditioner will run Anti-mildew function for 7-10 minutes, if turns off on HEAT mode, the unit
will continue operating for about 30 seconds at LOW fan speed, then stop the operation and
turn
off the unit automatically.
8. Dripping water may generate on the surface of the indoor unit when cooling in a high
relatively humidity (relative humidity higher than 80%). Adjust the horizontal louver to the
maximum air outlet position and select HIGH fan speed.
9. Heating mode (For cooling and heating models only)
The air conditioner draws in heat from the outdoor unit and releases it via the indoor unit
during heating operation. When the outdoor temperature falls, heat drawn in by the air
conditioner decreases accordingly. At the same time, heat loading of the air conditioner
increases due to larger difference between indoor and outdoor temperature. If a comfortable
temperature can't be achieved by the air conditioner, we suggest you use a supplementary
heating device.
10. Auto-restart function
Power failure during operation will stop the unit completely.
For the unit without Auto-restart feature, when the power restores, the OPERATION indicator
on the indoor unit starts flashing. To restart the operation, push the ON/OFF button on the
remote controller. For the unit with Auto-restart feature, when the power restores, the unit
restarts automatically with all the previous settings preserved by the memory function.
Publicidad
