Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING GUIDE
-OPERATION (RUN) indicator or
other indicators continue flashing.
Trouble
If one of the following code
appears on the display area :
E0,E1,E2,E3.....or P0,P1,P2, P3...., or
F1,F2,F3.......
-Fuse blows frequently or circuit
breaker trips frequently.
-Other objects or water fall into the
air conditioner. Terrible odors are
smelled or abnormal sounds
Malfunctions
Unit does not start
Cause
Power cut
Unit may have become
Unplugged.
Fuse may have blown.
Battery in remote controller
may have been exhausted.
The timer you have set with
timer is incorrect.
-The unit may stop operation or
continue to run in a safety
condition (depending on models).
Waiting for about 10 minutes, the
fault may be recovered
automatically, if not, disconnect
the power and then connect it in
again. If the problem still exists,
disconnect the power and contact
the nearest customer service
center.
-Stop the air conditioner immedi-
ately, disconnect the power and
contact the nearest customer
service center.
What should be done?
Wait for power to be restored
Check that plug is securely in
wall receptacle.
Replace the fuse
Replace the battery
Wait or cancel timer setting.
A/C
TAS012112MD
Publicidad
Tabla de contenido
