Battery Status; Battery Charging; Replacing The Battery - LaserLiner NovaMaster 800 Manual De Instrucciones

1
Light levels
1. Click: hold the button down
for 1 or 2 seconds: Switch on /
light level: high mode
2. Click Medium mode
3. Click: Low mode
4. Double click: boost mode
5. Click: hold down for 1 or 2
seconds: switch off
ON
1.
Click
400 lm
2 sec HIGH
2

Battery status

1 LED: < 25%
2 LEDs: 25–50%
3 LEDs: 50–75%
4 LEDs: 75–100%
3

Battery charging

1. Remove rubber cover
2. Connect the device to a
power source using the
USB-C interface and USB-C
cable.
3. Stop charging when the
battery charge display on
the base of the device
lights up green.
Red LED: charging
Green LED: battery fully
charged
4

Replacing the battery

1. Undo the screw on the base
of the housing.
2. Withdraw the battery slide.
3. Remove the battery from
the battery slide.
4. Place new batteries in the
battery slide, checking for
correct polarity.
5. Push the battery slide into the housing.
6. Tighten the screw.
08
EN
2. 3.
1x Click 1x Click
200 lm 100 lm
MEDIUM LOW
OFF
4. 5.
2x Click Click
800 lm
BOOST 2 sec
3