Recording To A Cassette Tape - Sharp CD-BK100W Manual De Manejo

Recording to a Cassette Tape

Before recording:
z When recording important selections, make a preliminary test to ensure that the
desired material is properly recorded.
z SHARP is not liable for damage or loss of your recording arising from malfunction
of this unit.
z The volume and sound controls can be adjusted with no effect on the recorded
signal (Variable Sound Monitor).
z For recording, use only normal tapes. Do not use metal or CrO tapes.
„ Recording from a CD (CDs)
You can record 3 CDs continuously.
1
Press the ON/STAND-BY button to turn the power on.
2
Load a cassette into the TAPE 2 cassette compartment.
Wind past the leader of the tape, on which recording cannot be performed.
3
Press the CD button and load the desired disc.
4
Press one of the 1 - 3 buttons on the remote control to select the
disc to be recorded first.
5
Press the REC PAUSE (
ton.
Recording will be paused.
6
Press the / (TAPE 2 ) button.
z Recording is started from the selected CD. When the playback of the last disc
is finished or the end of the tape is reached, the CD and the cassette will stop
automatically.
z CD playback will start approximately 7 seconds after the tape starts.
To perform programmed recording:
1 Programme discs and tracks.
2 Press the REC PAUSE ( ) button.
3 Press the / (TAPE 2 ) button.
To stop recording:
Press the (TAPE ) button.
The CD and tape will stop.
Note:
When the end of the tape is reached whilst recording, the unit will display the track
number which was being played at that time, and stop automatically. If you want to
restart recording from the interrupted track, turn over the tape, press the REC PAUSE
( ) button and then the / (TAPE 2
memory using the programmed recording, recording will restart from the first track
stored in memory.)
Programmed Play (See page 15.)
) but-
) button. (If tracks have been stored in
ENGLISH
CD-BK100W
E-20