Game ready HALF LEG BOOT Manual Del Usuario

FOR USE WITH
GAME READY
GRPRO 2.1 SYSTEM
®
MED4 ELITE™ SYSTEM
SIZING SPECIFICATIONS
• Size: One Size
• Length: 19"
ASSEMBLY
The Heat Exchanger
(PN 520906-03)
comes as part of a pre-assembled Wrap
Exchanger is removed to launder the Sleeve, or for any other reason,
please use the following instructions to re-insert the Heat Exchanger
into the Sleeve.
Place the Sleeve on a flat surface
1
with logo side up, and determine the
opening location.
Insert the Heat Exchanger
2
into the Sleeve with the
blue side down (The blue side of
the Heat Exchanger should
touch the blue side of the
Sleeve).
REMOVAL OF HEAT EXCHANGER
1. Disconnect the Connector Hose from the Wrap
2. Unzip the zipper
3. Gently pull out the Heat Exchanger
fits inside the Sleeve
(PN 510906)
. If the Heat
(PN 590906-03)
WARNING
It is mandatory to fully read and understand your
System's User Manual before using the device.
Failure to follow operating instructions could result in
serious injury.
IMPORTANT
and
Read complete indications, contraindications,
cautions, and warning before using this product.
Keep this document for future reference.
Be sure the Heat Exchanger is flat
3
inside the Sleeve with no folds or
creases. Zip up the Sleeve, if applicable.
After assembly, lay the blue side up and
ensure the Heat Exchanger is uniformly
laid out and smooth inside the Sleeve.
STORAGE OF YOUR WRAP
Hang your Wrap on a wide hanger or lay flat. Do not fold or stack it, as
this could kink the fluid chamber and the Wrap will not work properly.
HALF LEG
BOOT
USE GUIDE
ENGLISH