Identification And Use Of The System Elements; Analogue Channel Processor - Televes 5096 Manual De Instrucciones

User manual

4. - IDENTIFICATION AND USE OF THE SYSTEM ELEMENTS

4.1.-Analogue Channel Processor. Front and side views
1
2
3
4
1.- Input signal 46 - 862 MHz
2.- RF output
3.- RF input (other channels for mixing)
4.- RF output (processed channel + other
channels)
Product reference
Indicate the programmed
output channel
5
6
7
8
5.- Programmer / PC / Modem socket RJ45
6.- Power connector
7.- ON LED
8.- Control bus connector
Note down the device's
5096
address in the Headend
Ch
Control (001 ... 254)
23

Analogue Channel Processor

The processor is housed in a zamak chassis,
in fully compilance with the CE regulations.
It features two options for controlling the
processor:
• Via the portable Programming Unit,
Televés ref. 7234.
• Via Televés headend control software
(local control: PC or remote control: via
Modem).
The processor´s front panel have four "F"
type connectors: two at the top and two at
the bottom.
The two connectors at the bottom make up
the output loopthrough (mixing of the
processed channel with the other
channels).
The same processor can be used as
frequency converter (Processor mode) or
with the same input and output frequency
(Amplifier mode).