SANUS VuePoint F35c Manual De Instrucciones página 9

3. Drill pilot holes using a 7/32 in. (5 mm) diameter drill bit. Remove wall plate template
IMPORTANT: Be sure to drill into the center of the stud.
IMPORTANT: Pilot holes must be drilled to a depth of 3 in. (75 mm).
4. Install wall plate using two lag bolts
17
plate.
CAUTION:
Avoid potential personal injury or property damage! Both lag bolts
movement of the wall plate
3
16
and two washers
18
. Ensure the wall plate is securely fastened to the wall before continuing on to the next step.
18
3 in.
(75 mm)
7/32 in.
(5 mm)
.
16
. Tighten the lag bolts only until they are pulled fi rmly against the wall
19
18 MUST BE fi rmly tightened to prevent unwanted
4
17
19
18
9