Conceptronic 150N Manual De Usuario página 10

ENGLISH
When the 150 Wireless USB Adapter is connected to your computer, you can proceed with installing the
N
Conceptronic drivers & software.
A. Insert the CD-ROM in the optical drive of your computer. The AutoPlay option will be shown automatically.
Click on "Run Autorun.exe" to start the autorun menu.
Note: If the AutoPlay option is not shown, you can start the autorun menu by browsing to "Computer" and
double clicking on your optical drive.
B. Select the option "Install Driver & Software" from the autorun menu. The installation wizard will appear.
Note: You might get a "User Account Control" warning message, which you will need to accept by clicking
on "Yes".
C. Select the language you want to use for the installer and click on "OK" to proceed.
D. Select "Install drivers and Conceptronic Wireless Network Config Utility" if you want to use the
Conceptronic software, or select "Install drivers only" if you want to use the standard Windows Wireless
Configuration utility. Click on "Next" to proceed.
E. Click on "Install" to install the driver and software.
F. A popup verifying that you have connected the hardware will be shown. Click on "OK" to proceed.
The drivers & software (if selected) will be installed on your computer.
Note: During the installation, you might get a "Windows Security" warning message, which you will need
to accept by clicking "Install this driver software anyway".
G. When the installation is finished, click on "Finish" to close the installation wizard.
H. The Conceptronic Wireless Network Config Utility will be shown if you have selected to install the drivers
and the software.
Note: It is recommended to restart your computer when the new hardware installation has been completed.
You can now proceed to chapter 4 to connect to a wireless network.
10
3. Driver & software installation