Initial Use; Inserting The Water Filter And Pre-Filter - Beurer maremed MK 500 Instrucciones De Uso

6. Initial use

6.1 Inserting the water filter and pre-filter

1. Open the cardboard packaging.
2. Remove the cover from the maremed
foam from the golden sensor pins on the underside of the cover.
3. Remove the film packaging from the water filter and take out the two pre-filters.
4. Remove the pre-filter holders from the device cover. Place the pre-filters into the two
pre-filter holders. The smooth, firm side must be positioned towards the inside of the
device.
5. Then place the pre-filter holders into the cover of the maremed
pre-filter holders, make sure that the triangle markings
markings are located on the underside of the pre-filter holders and on the underside
of the cover.
+
in an upward direction. Remove the protective
®
=
30
When inserting the
® .
are aligned. The triangle