Hilti NURON NCT 25 S-22 Manual De Instrucciones Original página 12

4.1 Battery
Battery operating voltage
Weight, battery
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
5 Preparations at the workplace
WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1 Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery. → page 6
5.2 Inserting the battery
WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
5.3 Removing the battery
1. Press the battery release button.
2. Remove the battery from the product.
5.4 Switching starting lock on/off
The cutting tool has a starting lock that can be optionally activated or deactivated. If the starting lock is
activated, the control switch has to be pressed twice to start the cutting operation. This prevents inadvertent
starting.
The factory default is starting lock deactivated.
1. Remove the battery. → page 8
2. Press and hold down the control switch.
3. Insert the battery into the cutting tool.
8 English
21.6 V
See the end of these
operating instructions
1 ℉ ... 140 ℉
(−17 ℃ ... 60 ℃)
−4 ℉ ... 104 ℉
(−20 ℃ ... 40 ℃)
14 ℉ ... 113 ℉
(−10 ℃ ... 45 ℃)
2321719
*2321719*