Candy A 9007 SMART Instrucciones Para El Empleo página 12

Regulating the water softener
with electronic programmer
The water softener can treat water with a hardness level of up to 90ofH (French
grading) or 50odH (German grading) through 8 settings.
The settings are listed in the table below:
Water
hardness
Level
°fH
(French)
0 0-5
1 6-10
2 11-20
3 21-30
4 31-40
5 41-50
6 51-60
7 61-90
The softener unit is set in the factory at level 4 (D4) as this satisfies the requirements
of the majority of users. Regulate the setting of your water softener unit according to
the degree of hardness of your water as follows: open the door, keep the delay start
button pressed in and at the same time press the stop/start button
The factory setting "D4" will appear on the display. To change the setting, press the
start delay button . Each time you press that button the setting will increase by
one level. When you have reached "D7", the display will go back to "D1".
When the required setting appears on the display, wait for an audible signal to
confirm that the new setting has been stored in memory.
START DELAY
DISPLAY
Water
Use of Water
hardness
regenerating softener
°dH
salt setting
(German)
0-3 NO D1
4-6 YES D1
7-11 YES D2
12-16 YES D3
17-22 YES D4
23-27 YES D5
28-33 YES D6
34-50 YES D7
STOP/START
BUTTON BUTTON
22
The waterblock system
.
I
The waterblock system has been designed to improve the
safety of your appliance, particularly when the machine is left
unattended.
The waterblock system actually prevents flooding which might
be caused by a machine malfunction or as a result of a fracture
on the pipes.
How does waterblock work
The sump located in the base of the appliance collects any
possible water leakage and operates a sensor which
subsequently activates a valve placed under the water tap and
stops any water from the supply even with the tap fully opened.
If the box containing the electrical parts is damaged, remove
the plug from the socket immediately.
To ensure perfect operation of the safety system, box "A" with
the hose, should be connected to the tap as shown in Figure
"1". The inlet hose should not be cut, as it contains parts under
load. If the hose is not long enough for correct connection, it
must be replaced with a longer one. The hose can be obtained
from your Service Agent.
Fig. 1
23
A