Set The Clock Manually - Explore Scientific WSH5002 Manual De Instrucciones

be set automatically. If it fails within 7 minutes,
RCC (atomic) setting will quit automatically. If that
happens, press and hold the [
initiate RCC (atomic) receiving.
NOTE: The interference from the power adapter will
affect RCC (atomic) reception. It is recommended to
place the power adapter at least 1m away from the
console to get the best RCC (atomic) reception.

SET THE CLOCK MANUALLY

1. Press and hold [ MODE ] button to enter into time
and date setting.
2. The setting parameter will flash.
3. Press [ ] button once, the figure will increase 1
unit. Press and hold the [
increase rapidly.
4. Press [ ] button once, the figure will decrease 1
unit. Press and hold the [
decrease rapidly.
5. Press [ MODE ] button to confirm setting and enter to
next parameter.
6. Sequence of setting:
- EU/AUS Version -
] button to re-
] button, the figures will
] button, the figures will
12/24h format  Hour  Minute  Year  Month
 Day  Language  Time zone  Key tone on /
off  Temperature unit (°C/°F)  Pressure unit
 Exit
- US Version -
12/24h format  Hour  Minute  Year  Month
 Day  Language  Time zone  DST ON/OFF
 Key tone on / off  Temperature unit (°C/°F) 
Pressure unit  Exit
7. If there is no action in 20 seconds, the setting will be
saved and you will exit the setting mode.
ALARM
SETTING/ADJUSTING ALARM TIME
1. Press and hold [ ALARM ] to enter alarm setting
mode.
2. The setting parameter will flash.
3. Press [ ] or [ ] button to set the desired data.
4. Press [ ALARM ] button to confirm setting and exit.
5.The alarm will sound when the alarm setting is
finished and turned on.
TURN ON/OFF ALARM
EN
IT
DE
FR
ES
NL
9