Publicidad
Step 13
If you have not assembled the 401448 Credenza,
å
assemble it now. If you assembled the 401448, then
you will need to remove the Credenza Top by loosening
the TWIST-LOCK® FASTENERS in the Ends and Back as
shown to the right.
Now, fi nish drilling out the four holes in the bottom surface
å
of the 401448 Credenza Top using a 1/4" drill bit.
Then, with the help of another person, carefully lay the Hutch
å
onto its back. Fasten the Credenza Top to the ENDS (A and B).
Use four BLACK 2-1/4" FLAT HEAD SCREWS (26S) as shown
below.
www.sauder.com/services
B
4 0 1
4 4 8
C r e
d e n
z a T
o p
26S
BLACK 2-1/4" FLAT HEAD SCREW
(4 used in this step)
A
419717
401448 Credenza
top removal
Loosen eight
TWIST-LOCK®
FASTENERS.
Page 17
Publicidad
