Liberty Pumps FL150-E Serie Manual Del Usuario página 3

1.
Safety Information

Always disconnect the pump from its power source before handling or making any adjustments to the pump.

Only qualified personnel should complete fixed wiring and electrical connections, according to all local and
national electrical codes, during a pump installation.

After installation, be certain that the pump is properly grounded, using its supplied grounding conductor.
Failure to properly ground the pump can cause all metal portions of the pump and any of its surroundings to
become energized.

During flood conditions, submerged electrical connections can energize the water. Always wear dielectric
rubber boots and other applicable Personal Protective Equipment (PPE) when water is on the floor and you
must service an energized pump. DO NOT ENTER THE WATER if the water level is higher than that of the
protection your PPE offers or if your PPE is not watertight.

DO NOT bypass grounding wires.

The electrical power supply shall be located within the length limitations of the pump power cord, and for
below grade installations it shall be at least 1.22 m (4 feet) above floor level.

NEVER lift or carry a pump by its power cord. This will damage the power cord, and could expose the
electrically live wires inside the power cord.

During construction, if the pump is installed before its power cord can be plugged in or direct wired, the power
cord must be protected from the environment to prevent water from wicking through the cord end into the
pump housing. If water enters the pump an electrical short can occur from the pump to its surroundings,
which will energize the surroundings.

NEVER use this product in applications where human contact with the pumped fluid is common (such as
swimming pools, fountains, marine areas, etc.).
This safety alert symbol in your manual and on the pump is intended to alert you to a
potential risk for injury or death.
This is a safety alert symbol identifying risk of electric shock. It will be accompanied with
an instruction intended to minimize your potential risk of electric shock.
This is a safety alert symbol identifying risk of fire. It will be accompanied with an
instruction intended to minimize your potential risk of fire.
This is a safety alert symbol identifying risk of injury or death. It will be accompanied with
an instruction intended to minimize your potential risk of injury or death.
Warns of hazards that will cause serious injury or death.
Warns of hazards that can or will cause minor or moderate injury.
Warns of hazards that can cause personal injury, death, or property damage.
Signals an important instruction related to the pump. Failure to follow these instructions
could result in pump component failure, or improper operation of the unit, possibly resulting
in property damage
RISK OF ELECTRIC SHOCK
electrically live parts, items, fluid, or water can cause serious
injury or death.
©Copyright 2014 Liberty Pumps Inc. All rights reserved
- Accidental contact with
3