Connecting Cable Tv - Samsung LN19R71B Instrucciones Del Propietario

Connecting Cable TV

To connect to a cable TV system, follow the instructions below.
Cable without a Cable Box
ANT IN
Connecting to a Cable Box that Descrambles All Channels
ANT IN ANT OUT
ANT IN
Connecting to a Cable Box that Descrambles Some Channels
If your cable box descrambles only some channels (such as premium channels), follow the instructions below. You will need a two-way splitter, an
RF (A/B) switch, and four lengths of RF cable. (These items are available at most electronics stores.)
Incoming
cable
Incoming
cable
Splitter
Incoming
cable
Splitter
Incoming
cable
Splitter
After you have made this connection, set the A/B switch to the "A" position for normal viewing. Set the A/B switch to the "B" position to view scrambled channels.
(When you set the A/B switch to "B", you will need to tune your TV to the cable box's output channel, which is usually channel 3 or 4.)
1. Plug the incoming cable into the ANT IN terminal on the back of the TV.
Because this TV is cable-ready, you do not need a cable box to view unscrambled cable channels.
1. Find the cable that is connected to the ANT OUT terminal on your cable box.
This terminal might be labeled "ANT OUT", "VHF OUT" or simply, "OUT".
2. Connect the other end of this cable to the ANT IN terminal on the back of the TV.
ANT IN
Incoming
cable
Splitter
Splitter
Cable Box
Cable Box
RF (A/B)
Cable Box Switch
1. Find and disconnect the cable that is
connected to the ANT IN terminal on your
cable box.
2. Connect this cable to a two-way splitter.
3. Connect an RF cable between an OUTPUT
terminal on the splitter and the IN terminal on
the cable box.
Cable Box
4. Connect an RF cable between the ANT OUT
terminal on the cable box and the B–IN terminal
on the RF(A/B) switch.
RF (A/B)
Switch
5. Connect another cable between the other OUT
terminal on the splitter and the A–IN terminal on
the RF (A/B) switch.
RF (A/B)
Switch
6. Connect the last RF cable between the OUT
ANT IN
terminal on the RF (A/B) switch and the ANT IN
terminal on the rear of the TV.
TV Rear
English-7
This terminal might be labeled "ANT IN", "VHF IN"
or simply, "IN".