Conformity Declaration - SEA SATURN 24V 1500 Instrucciones De Montaje Y Conexión

Sistemi elettronici
di Aperture Porte e Cancelli

CONFORMITY DECLARATION

SEA declares under its proper responsability that the product
Saturn 24V 1500
fulfils the essential requirements foreseen from the following European laws and successive modifications (where applicable):
89/392/CEE (Machine Directive)
89/336/CEE (Electromagnetic Compatibility Directive)
73/23/CEE (Low Tension Directive)
SAFETY PRECAUTIONS:
All electrical work and the choice of the operating logic should conform to current regulations. A 16 A 0,030 A differential switch must
be incorporated into the source of the operators main electrical supply and the entire system properly earth bonded. Always run
mains carrying cables in separate ducts to low voltage control cables to prevent mains interference.
INTENDED USE:
The SATURN operator has been designed to be solely used for the automation of sliding gates.
SPARE PARTS:
To obtain spare parts contact:
SEA s.r.l. -Zona Ind.le, 64020 S. ATTO Teramo Italia
SAFETY AND ENVIRONMENTAL COMPATIBILITY:
Don't waste product packing materials and/or circuits.
When being transported this product must be properly packaged and handled with care.
MAINTENANCE AND OUT OF SERVICE:
The decommission and maintenance of this unit must only be carried out by specialised and authorised personnel.
NOTE: THE MANUFACTURER CANNOT BE DEEMED RESPONSIBLE FOR ANY DAMAGE OR INJURY CAUSED BY
IMPROPER USE OF THIS PRODUCT.
SEA reserves the right to do changes or variations that may be necessary to its products with no obligation to notice.
cod. 67410328 REV 00 - 11/2007
6/30