AquaSource 67157-1027H2 Manual De Instrucciones página 4

ASSEMBLY INSTRUCTIONS
2. Install the faucet:
a. Remove the preassembled mounting
nuts (B) from the faucet (A) and place
the faucet (A) in position on the sink.
Note: If the sink surface is uneven, use
silicone sealant (not included) to create
a watertight seal.
b. From under the sink, thread the
mounting nuts (B) onto the faucet (A).
c. Tighten the mounting nuts (B).
Note: Tighten mounting nuts until snug.
Do not overtighten.
3. Remove the lock nut (F) from the hose
guide (E). Mount the hose guide (E) into the
far-right hole in the sink. Secure the hose
guide (E) underneath the sink using the
lock nut (F) and hand tighten.
4. Install the side spray:
a. Insert the side spray (D) down through the
hose guide (E) and into the sink.
b. From under the sink, push the
upward and snap onto the block (C).
c. Pull down moderately to ensure the con-
nection has been made.
If it is necessary to remove the hose, press
down on the tabs and pull the hose connector
(G) down.
2
B
3
4
C
G
4
A
E
F
D
E
Lowes.com