Care and maintenance
Cleaning the filters
The filters remove food residue from the water used
in the wash cycle: to obtain the best results from
each wash, they should be cleaned.
Clean the filters regularly.
After cleaning check that the filter assembly has
been replaced correctly.
The dishwasher should not be used without filters.
1. Remove the filters by pulling the handle upwards.
2. Clean the filters:
C
1
2
A
B
C
B
A
direction). Use a small non-metallic brush to clean
these parts.
3. Reconstruct the filter assembly and replace it in
the correct position, following movements 1 and 2 as
shown in the figure, until it clicks into place.
Leaving the machine unused for
extended periods
• Run a wash cycle when the dishwasher is empty.
• Unplug the appliance and disconnect the water
supply.
• Leave the door of the appliance ajar.
• after every wash
cycle, remove the
largest pieces of
residue from
semicircular plate A
and glass B (these
may be removed by
pulling the handle) by
rinsing them under
running water.
• The entire filter
assembly should be
cleaned thoroughly
once a month: this
includes the
semicircular plate A,
the glass B and the
cylinder C (this may be
removed by turning it in
an anti-clockwise
21
EN