Kärcher WD 6 P Premium Renovation Manual De Instrucciones página 15

Information filter bag
– The filling level of the filter bag depends on the dirt
that is sucked in.
– The filter bag needs to be replaced more frequently
while sucking in fine dust, sand, etc.
– Clogged filter bags can burst - therefore make sure
to replace the filter bag in a timely manner!
ATTENTION
Vacuum cold ashes only when using a pre-filter.
Order no. basic design: 2.863-139.0, premium design:
2.863-161.0.
Wet vacuum cleaning
ATTENTION
Do not use a filter bag!
Note: If the container is full, a float closes the suction
opening, and the appliance works at a higher speed.
Switch off the appliance immediately, and empty the
container.
 For vacuuming up moisture or wetness pay atten-
tion to the correct floor nozzle setting and connect
the corresponding accessories.
Vacuuming up coarse dirt
Illustration
 Use the coarse dirt hose, coarse dirt pipes and
coarse dirt nozzle to vacuum up coarse dirt and
stones.
ATTENTION
Coarse dirt may only be vacuumed up without the filter
bag being inserted, otherwise the filter bag can get dam-
aged.
Working with electrical power tools
 Adapt the adapter to the connection diameter of the
electric tool using a knife if necessary.
Illustration
 A) Plug the enclosed adapter onto the handle of the
suction hose and connect the electric tool with the
connection.
or
 B) Use the flexible tool hose to gain more flexibility
in your work. Connect this hose to the suction hose
and to the adapter and then to the connection of the
electric tool.
Illustration
 Connect the mains plug of the electric power tool to
the vacuum cleaner.
Illustration
 Switch the appliance on (move the rotary switch to
the left to position
Note: As soon as the electric tool is switched on, the
suction turbine starts with a 0.5 second delay. If the
electric tool is switched off, the suction turbine contin-
ues to run for approx. 5 seconds in order to vacuum up
the remaining dirt in the suction hose.
MAX) and start working.
Integrated filter cleaning system
The filter cleaning system is intended for vacuuming up
large volumes of fine dust without an inserted filter bag.
Note: Thanks to the filter cleaning system the soiled flat
pleated filter can be cleaned at the push of the button
and the suction performance can be increased again.
Illustration
 Place the handle of the suction hose in the acces-
sory compartment on the appliance head. Push the
filter cleaning button 3 x while the appliance is
switched on, wait 4 seconds between the individual
operations.
Note: After operating the filter cleaning button several
times, check the container for its filling volume. Other-
wise, the dirt might escape when the container is
opened.
Cleaning hard to reach locations or, where vacuuming
is not possible, like leaves from a gravel bed.
Illustration
 Connect the suction hose to the blower connection,
this will activate the blower function.
Interrupting operation
Illustration
 Turn off the appliance.
Illustration
 Hook the floor nozzle into the parking position.
 Turn off the appliance and disconnect the mains
plug.
Empty the container
Illustration
 Remove the appliance head and empty the reser-
voir filled with wet or dry dirt.
For appliances with drain screw: Empty the dry
dirt over the container. Use the drain screw to emp-
ty liquids.
Storing the appliance
Illustration
 Stow away the mains cable and accessory at the
machine. Store the appliance in a dry room.
– 9
EN
Blowing function
Finish operation
15