Settings; Speaker Size/Distance/Filter - Panasonic SA-HR50 Instrucciones De Funcionamiento

Settings

Change the settings to suit your equipment to the environment in which you are using it. Before making any changes, read the
descriptions of the settings, note the factory settings and ranges, and refer to the equipment's instructions.
1 Enter the setup
mode.
MENU
SETUP
RETURN
Press and hold.
Note
• For "Speaker size" and "Filter", change the settings only if auto speaker setup has not produced a satisfactory result.
• Auto speaker setup calibration will give optimal result for "DISTANCE". Therefore, you are not able to check the setting while it is
in use.
Speaker size
•
LARGE: Speakers that can reproduce a full sound range (bass below 100 Hz).
SMALL: Speakers that cannot adequately reproduce the bass range (sufficient for
most speakers when using a subwoofer).
NONE: Speakers not connected (center or surround).
The factory settings are:
LR (front), C (center), and S (surround): SMALL
For SUBW (subwoofer), select YES (factory setting) if you have connected one, or
NO if not.
• Enter the distance of the front, center and surround speakers
Distance
from the seating position.
Change the distance so that the sound from all the speakers (except for the
subwoofer) reaches you at the same time.
You can select distances between 1.0 and 10.0 m.
The factory settings are:
Filter
• Change the cut-off for bass output from the front speakers.
For large speakers with satisfactory bass, set the filter to 80 Hz or 100 Hz.
For small speakers with unsatisfactory bass, raise the cut-off so the subwoofer
outputs more. (You may also have to change the filter settings on your subwoofer.)
The settings are 80 Hz, 100 Hz (factory setting), 120 Hz, 150 Hz, and 200 Hz.
12
12 12
SA-HR50 (RQTV0259-E).indb 12
2 Select the item you want to change.
TUNE
2a
Select and press [ENTER].
SPK SIZE ↔ DISTANCE ↔ FILTER FRQ ↔
AUTO SETUP ↔ INPUT MODE ↔ HDMI ↔
DRCOMP ↔ ATTENUATOR ↔ REMOTE ↔
TV DELAY ↔ RESET ↔ EXIT
• Refer to pages 12, 13, and 20 for each item
settings.
• For "REMOTE", refer to page 21.
• For "RESET", refer to page 17.
2b
Select and press [ENTER].
Set the size to suit your speakers.
3.0 m (meters)
L, R (front):
3.0 m (meters)
C (center):
1.5 m (meters)
SL, SR (surround):
3 Change the
setting.
ENTER
Press to change the
setting.
Press once to enter.
SPK SIZE
DISTANCE
FILTER FRQ 80
4 Exit the setup
mode.
MENU
SETUP
TUNE
RETURN
Press repeatedly
until "EXIT" appears.
ENTER ENTER
Press [ENTER] to
completely exit the
setup mode.
3
2a 2b
SUBW NO
YES
LR
SMALL
LARGE
C
NONE
SMALL
S
LARGE
RETURN
Repeat for each speaker channel
L
R
1.0m to
C
10.0m
SL
SR
Repeat for each speaker channel
100
120
150
200
8/24/2007 10:10:20 AM