Publicidad
Idiomas disponibles
Idiomas disponibles
27.- Attach the end of the cable to the
"U" on the tube (8) for the gluteal
support using screw (113) along with
washers (120) and nut (73), Fig.19.
Note: After a while you may notice
that the steel cable slackens a little
due to the cable settling into position.
To remedy this, just tighten the steel
cable (65) and (67) on the tensioning
nut (49).
28.- FITTING THE FOAM
COVERS.-
First take the top leg tube (26) and fit
and insert it into the leg support (3),
Fig.20, fit the foam covers (91) onto
the rounded ends of the leg support,
Fig.20.
Now do the same for the bottom foam
covers (91) for the leg support (18).
Finally, fit the caps (79) onto the ends
of the foam covers (91), Fig.20.
29.- Attach the end of cable (64) to the
carabiner (59) and the chain (58),
Fig.20.
30.- FITTING THE SEAT &
GLUTEAL BACKREST.-
Take the seat (40) and position it on
the seat support (19), Fig.21. Attach
using screws (115) and washers (119).
Take the backrest (38) and position it
on the abdominal support (17), as
shown in Fig.21.
Now use screws (112) and washers
(119) to secure the backrest, Fig.21.
Take the headrest (42) and position it
on the main body (5), as shown in
Fig.21.
Now use screws (115) and washers
(119) to secure the backrest, Fig.21.
31.- FITTING THE SEAT &
GLUTEAL BACKREST.-
Pulling knob (56) outward, Fig.22,
insert the back support (27) into the
boss on the gluteal support (8), Fig.22.
Position it at one of the backrest
distance holes and release the knob
(56).
Take the backrest (39) and position it
on the backrest support (27), as
shown in Fig.22.
Now use screws (115) and washers
(119) to secure the backrest, Fig.22.
Take the seat (41) and position it on
the seat support (8), Fig.22.
Fit screws (115) with their washers
(119) and tighten securely.
32.- CASING ASSEMBLY.-
Fit the front left and front right safety
covers (36 and 37) onto the top casing
bracket (10), Fig.23, hand tightening
screws (116) along with the washers
(119) on the top section, Fig.23.
Also fit covers on the the bottom bracket
(4) Fig.23, using screws (116) with
washers (119), on the bottom section,
Fig.23.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE.
35
Publicidad
