Electrical Safety - Black and Decker BHFEV362DA Manual De Instrucciones

Other batteries could burst, causing
personal injury and damage.
Never attempt to charge non-
u
rechargeable batteries.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The appliance/battery must be
u
placed in a well ventilated area when
charging.

Electrical safety

Symbols on the charger
+
Read all of this manual carefully before using the
#
appliance.
S010Q 23
This tool is double insulated; therefore no earth wire
SSC-360040**
is required. Always check that the power supply
$
corresponds to the voltage on the rating plate.
The charging base is intended for indoor use only.
Labels on appliance
+
The following symbols appear on this appliance along with the
date code
Read all of this manual carefully before
using the appliance
BHFEV362DA, BHFEV362D,
BHFEV362DP, BHFEV36B2D use charger
SSC-360040**
Features
This tool includes some or all of the following features.
1. On/Off button
2. 3 speed power switch
2a. Beater bar activation button
3. State of charge indicator
3a. Filter sense
(Original instructions)
4. 36V Battery (available with units BHFEV362DA,
BHFEV362D, BHFEV362DP, BHFEV36B2D)
5. 36V cup charger and charging station (available with units
BHFEV362DA, BHFEV362D, BHFEV362DP)
6. Lift away dust canister with filter agitator
7. Dust canister door
8. Floor head
9. Extension tube
10. 2 in 1 Accesssory tool (available with units BHFEV362DA,
BHFEV362D, BHFEV362DP, BHFEV36B2D)
11. Crevice tool (available to order through service
department)
12. Accessory storage clip
13. Pet hair tool (available with units BHFEV182CP)
14. Wide mouth dust brush (available with units
BHFEV362DA)
15. Charge port
Charging a Battery
BLACK+DECKER chargers are designed to charge
BLACK+DECKER battery packs.
Note: To ensure maximum performance and life of lithium
ion battery packs:
Charge the battery pack fully before first use.
u
Recharge discharged batteries as soon as possible
u
after every use.
Do not discharge batteries fully.
u
The supplied charger offers three possible ways to charge
your battery.
1. Standard cup charging only
2. Wall mounted cup charging
3. Wall mounted suspended charging
1. Standard cup charging (Fig. A)
Plug the charger (5) into an appropriate outlet before
u
inserting the battery pack (4).
Insert the battery pack into the cup charger.
u
When using the the cup charger a green LED will flash
u
indicating that the battery is being charged.
The completion of charge is indicated by the green LED
u
remaining on continuously. The pack is fully charged
and may be used at this time or left on the charger.
The cup charger can be inserted into the charging station
u
(5a) as shown in figure A.
2. Wall mounted battery charging
Mark the location of the charging station screw holes on
u
the wall (within reach of an electrical outlet for charging
the vacuum while it is on the charging station.
Fix the charging station (5a) to the wall using
u
appropriate screws and plugs for the type of wall, and
weight of the appliance.
Install the cup charger into the charging station (5a).
u
ENGLISH
7