Installing The Footrests - Bellelli B-FIX RELAX Manual De Instrucciones

EN EN
Leave enough legroom for the child.
WARNING: If the seat touches the wheel or interferes with the bike pedals, reposition the mounting
support (see the previous section "Mounting Support Installation').
Tighten the nuts (8) on the mounting support, once you have determined the best location for the
seat.
WARNING: Check to make sure that tightened nuts completely cover the threads (fig. E). If this is not
the case, the mounting support is not properly attached.
Attach the cover (1) by pushing against the front of the mounting support so that it locks into place
on the sides of the mounting support where the corresponding notches are located. For a correctly
positioned cover, make sure that the rectangular indentation is directed upward. A click shows a
successful mounting.
The correct choice of the components, in particular the screws ensures that the they do not emerge
from the cover. Lock the mounting support by turning the key to the "closed" position (Fig. F).
WARNING: Check the tightening of the screw regularly. These can come loose during use.
Removing the Seat from the Bike
Place the security system / Burglar in the open position.
Press and hold the button (6) on the mounting support and pull the seat upwards (fig. L).

Installing the Footrests

Take the left footrest (25) (L symbol printed on the back).
Insert it into the vertical slot of the left leg strap.
Push it all the way up (fig. M).
Take the catch lever (23) of the left footrest (L symbol printed on the back).
Insert the catch lever into the hole on the backside of the footrest. Insert it from the outside and push
it all the way through to the back (fig. N).
Close the locking lever by pushing it down until you hear a click (fig. O).
Repeat the same operations for the right footrest (symbol R).
USE AND ADJUSTMENT OF THE SEAT
Before using the seat, check that the position of the safety straps and the footrests correspond to
your child's size.
WARNING: Do not configure the safety straps and the footrests with your child in the seat.
The straps must be located in a position just above the child's shoulders.
The feet of the child must fully rest on the footrests.
Adjusting the Safety Straps
To adjust the straps from one location to the other:
- take the plastic buckle located behind the backrest of the seat and pull the belt (20) and buckle
from the opening of the backrest;
- insert the belt and buckle through the hole of the backrest to the desired height (fig. P);
- repeat the same operation for the other belt.
REMARK: Refer to the figure P/TIGER for the TIGER seat.
19