Warranty & Service - Whirlpool ADN 231 Manual De Instrucciones

OPERATION PROBLEMS AND THEIR SOLUTIONS (TROUBLESHOOTING)
What if ...
The appliance is plugged in to the mains but it does not work and the electricity
•
supply voltage indicator is not illuminated. Check that your house electricity supply
installations are in order.
supply socket.
The noise has become louder. Check that the appliance is standing stable, on a level
•
place. To make it level, regulate the front feet. Check if the appliance is not touching any
furniture, and that no part of the refrigeration system at the back part of the appliance
body is touching the wall. Pull the appliance away from any furniture or walls. Check that
the cause of increased noise isn't due to bottles, cans in the appliance that might be
touching each other.
Water has appeared at the bottom of the refrigerator compartment.
•
whether a thaw water channel space isn't blocked. Clean the thaw water channel space
with a cleaner intended for that purpose.
Water has appeared under the appliance. The thaw water collection tray has slipped
•
off the compressor. Place the tray on top of the compressor.
When the appliance door is opened, the rubber sealing gasket pulls out. The
•
gasket is smeared with sticky foodstuffs (fat, syrup). Clean the sealing gasket and the
groove for it with warm water containing soap or dishwashing detergent and wipe dry.
Put the rubber sealing gasket back into the place.
High temperature in appliance, the compressor operation pauses are short.
•
Ascertain whether the appliance door/doors are shutting tightly, whether the door wasn't
kept open longer than necessary when taking out or putting in foodstuffs.
The top of the appliance has condensation on it. The ambient relative air humidity is
•
above 70 %. Ventilate the room where the appliance stands and if possible remove the
cause of the humidity.
THE MANUFACTURER WILL NOT BE RESPONSIBLE FOR ANY DAMAGE OF THE
APPLIANCE THAT RESULTS FROM NON-COMPLIANCE WITH THE INSTRUCTIONS FOR
TRANSPORTATION.
The appliance should be transported only in the vertical position.
•
When being transported, the appliance should be protected from atmospheric conditions
•
(rain, snow, dampness).
The appliance should be firmly secured in place while being transported, to avoid slippage
•
or any shocks in the transport vehicle.
If the appliance was transported not vertically, it may be connected to the
•
mains after 4 hours at least. If this is not done, the appliance compressor may
fail.
IF YOUR APPLIANCE IS NOT WORKING PROPERLY, ASCERTAIN WHETHER YOU CAN
REMEDY THE CAUSE OF THE FAULTY FUNCTIONING OF THE APPLIANCE YOURSELF. If you
cannot solve the problem yourself, contact the nearest refrigerator service representative by
telephone or in writing. When making contact necessarily indicate the refrigerator model and
number. You will find this data on the product label, which is glued to the wall of the
refrigerator compartment.
Check that the plug is correctly inserted into the electricity
TRANSPORT
WARRANTY SERVICE
9
Check