Read the instructions, keep them safe, pass them on if you pass the appliance on. Remove all
packaging before use.
A IMPORTANT SAFEGUARDS
Follow basic safety precautions, including:
1 This appliance can be used by persons with reduced physical,
sensory or mental capabilities or lack of experience and
knowledge if they have been supervised/instructed and
understand the hazards involved.
• Children must not use or play with the appliance.
• Keep the appliance and cable out of reach of children.
& To avoid injury, take care handling the blades, emptying the jug,
and cleaning.
$ Do not add hot liquid (over 40°C), as it may be ejected due to
sudden steaming.
2 Misuse of the appliance may cause injury.
3 Unplug the appliance before assembly, disassembly, or cleaning.
4 Don't leave the appliance unattended while plugged in.
5 If the cable is damaged, it must be replaced by the manufacturer,
its service agent, or someone similarly qualified, to avoid hazard.
H Don't put the motor unit in liquid.
6 Switch off (0) before fitting the jug to the motor unit.
7 Switch off (0), and wait till the blades come to a stop before removing the lid from the jug, or
removing the jug from the motor unit.
8 Don't put utensils into the jug while the appliance is plugged in.
9 Don't use accessories or attachments other than those we supply.
10 Don't use the appliance for any purpose other than those described in these instructions.
11 Don't operate the appliance if it's damaged or malfunctions.
C PREPARATION
1 Sit the motor unit on a stable, level surface.
2 Align the d on the bottom of the jug with the U on the motor unit.
3 Lower the jug on to the motor unit, then turn the jug to align the d with the L.
4 Remove the lid.
5 Put the ingredients into the jug.
6 Don't fill past the 1.5l mark. If you do, the contents may force the lid off when you start the
motor.
7 Don't fill with anything hotter than you can comfortably handle (i.e. liquid temperature
below 40°C).
8 Replace the lid.
9 Don't run the appliance without fitting the cap.
C SWITCH ON
10 Check that the speed control is set to 0.
11 Put the plug into the power socket.
household use only
66