BAUKER CMS185S Manual De Instrucciones página 39

NOTE. Before using the tool, read the instruction book carefully.
INTENDED USE
The machine is intended for lengthways and crossways cutting of wood with straight
cutting lines as well as bevel angles to 50° while resting firmly on the work piece.
Charging your battery pack
The battery charger supplied is matched to the Li-ion battery installed in the machine.
Do not use any other battery charger.
The Li-ion battery is protected against deep discharging.When the battery is empty, the
machine is switched off by means of a protective circuit: The tool holder no longer
rotates.
In a warm environment or after heavy use, the battery pack may become too hot. Allow
the battery to cool down before recharging.
important notes for
charging theBattery
The battery in your new tool is not charged when it leaves the plant. Therefore it must
be charged before using the first time!
NOTE: If the battery pack is very hot you must remove your battery pack from the tool
and allow your battery pack to cool first to ambient temperature and then recharging can
be started.
To prevent damage to the Battery Pack, when charge runs out, please charge the battery
to reach full or no less than half charge before storage.
If the tool will not be used for long periods of time, charge the battery every 3-6 months
71
Operating instructions Indicating the remaining battery capacity
Press the check button on the battery cartridge to indicate the remaining
battery capacity. The indicator lamps light up for few seconds.
Charger level Amount of charge Fig. A: Charger level indicator.
indicator remaining
0 % - 10 %
10 % - 25 %
NOTE: Depending on the conditions of use
and the ambient temperature, the
25 % - 50 %
indication may differ slightly from the
actual capacity.
50 % - 75 %
75 % - 100 %
To remove or instal battery pack
WARNING: Never outlet the battery pack while the tool is working.
Depress the battery pack lock button to release and slide the battery pack out from
your tool. After recharge, slide it back into your tool. A simple push and slight pressure
will be sufficient.
CHARGING THE BATTERY PACK
1. The battery charge supplied is matched tothe battery installed in the machine. Do
not use another battery charger.
2. The battery pack is protected against deep discharging. When the battery pack is
empty, the machine is switched off by means of a protective circuit.
3. Connect the charger to the power supply and the power on LED indicator lights will
showing. Slide the battery pack into the charger to make the connections.
BATTERY POWER CHECK
Before working, press the ON button which is at battery surface, it will active battery
and showing battery power several seconds.
Battery
72