BAUKER CMS185S Manual De Instrucciones página 45

The depth of cut can be preset for even and repetitive shallow cuts.
1. Slide the stop plate (24) towards the front position.
2. Loosen the lock nut (25) to free the lock knob (23), turn the stop knob until the cutting
head down until the teeth of the blade are at the desired depth.
3. While holding the upper arm in that position, tighten the lock nut to secured the stop
knob.
4. Recheck the blade depth by moving the cutting head front to back through the full
motion of typical cut along the control arm.
WARNING! Always remove battery pack from your tool when you are assembling parts,
making adjusments, cleaning, or when not in use. Removing battery pack will prevent
accidental starting that could cause serious personal injury.
81
Setting cutting depth
Maintenance
ENVIRONMENTAL PROTECTION
Information for the environmentally responsible disposal of electrical and electronic
equipment waste (WEEE), for private users.
This symbol on the products or accompanying documents means
that used electrical and electronic equipment should not be disposed
of with general household waste.
For proper disposal, treatment, recovery and recycling, take these
products to the designated collection points, where they will be
accepted free of charge. Alternatively, in some countries, you may be
able to return your products to your local retailer upon purchase of
an equivalent new product. Disposing this product correctly will help to save valuable
resources and prevent any potential negative effects on human health and the
environment, which could otherwise arise from inappropriate waste handling and
disposal. Please contact your local authorities for further details on your nearest
designated collection point. Penalties may apply for the incorrect disposal of these
wastes, in accordance with your local legislation.
If you wish to discard electrical and electronic equipment, please contact your local
authorities or your retailer for information on the correct disposal method.
SYMBOLS
The data plate of your product may contain some symbols. They represent important
information about the product or instructions for use.
Wear hearing protection
Wear eye protection
Wear respiratory protection
Read the instruction manual
General warning
Electrical items and electronic devices should not be disposed of with household waste.
Recycle them in the corresponding facilities.
Contact your local authorities or distributor for information on recycling.
Maintence
In compliance with safety standards
The product is in compliance with RoHs
It contains lithium ions
82