Trigger Pads - Subzero MiniCommand Manual Del Usuario

Trigger pads

The trigger pads can transmit note messages or
control change messages. For each trigger pad,
you can individually specify the assigned message,
the MIDI transmit channel, the behavior of the
trigger pad, the note number, the control change
number and the values transmitted when the pad
turns on or off.
Depending on its assign type, the note number
or control change number can be assigned to a
single trigger pad and transmitted. If you transmit
note messages or control change messages from a
trigger pad, all of the messages will be transmitted
at the velocity or On Value/Off Value.
MIDI Channel [1 to 16 / Global MIDI Channel]
This specifies the MIDI channel of the MIDI
messages that are transmitted when you strike the
trigger pad. If you set this to Global MIDI Channel,
the messages will be transmitted on the global
MIDI channel.
Assign Type [No Assign/Note/Control Change]
This specifies the type of message that will be
assigned to the trigger pad.
Pad Behavior [Momentary/Toggle]
You can choose one of the following two types
of behavior for the trigger pad:
Momentary The Note On/On Value will be
transmitted when you press the trigger pad,
and the Note Off/Off Value will be transmitted
when you release it.
Toggle The Note On/On Value will be
transmitted alternately with the Note Off/Off
Value each time you press the trigger pad.
Note Number [C-1 to G9/No Assign]
This specifies the note number of the note message
that is transmitted.
Control Change Number
[0...127/No Assign] [0 to 127]
This specifies the control change number of the
control change message that is transmitted.
On Value [0 to 127]
This specifies the value of the message that is
transmitted when the trigger pad turns on.
Off Value [0 to 127]
This specifies the value of the message that is
transmitted when the trigger pad turns off.
(*Note: You can only set this if the assign type is
Control Change.)
8