Conceptronic Powerline CPNP200IP Guía De Instalación Rápida página 6

ENGLISH
3.2 Create a new individual Powerline network
 Press and hold the 'S' button on the 1
button when the power LED flashes. The default password has now been erased from the
adapter.
 Press and hold the 'S' button on the 2
button when the power LED flashes. The default password has now been erased from the
adapter.
Both adapters are now not connected to any network.
 Press and hold the 'S' button on the 1
start to flash, indicating that the pairing mode is enabled. This pairing mode will be active
for 120 seconds.
 Press and hold the 'S' button on the 2
will start to flash and the 2
Powerline adapter.
Both adapters are now in a new Powerline network with a unique security key.
rd
3.3 Adding a 3 Powerline adapter to your individual Powerline network
 Press and hold the 'S' button on the 3
button when the power LED flashes. The default password has now been erased from the
adapter.
 Press and hold the 'S' button on the 1
start to flash, indicating that the pairing mode is enabled. This pairing mode will be active
for 120 seconds.
 Press and hold the 'S' button on the 3
start to flash and the 3
Powerline network.
Note: To add more Powerline adapters, repeat the steps in chapter 3.3 for each adapter.
3.4 Reset Powerline adapters
You can reset the Powerline adapters to the factory default settings.
 Press and hold the 'R' button on the Powerline adapter for 2 seconds. When you release the
'R' button, all the LEDs will turn off and on again.
The Powerline adapter is now set to the factory default settings.
Enjoy the use of your Powerline network.
Note: For advanced Powerline adapter configuration options (advanced users only), you can
download The Powerline Configuration Utility (for Windows only) from the
Conceptronic website: www.conceptronic.net/support
6
st
Powerline adapter for 10 seconds. Release the
nd
Powerline adapter for 10 seconds. Release the
st
Powerline adapter for 2 seconds. The power LED will
nd
Powerline adapter for 2 seconds. The Power LED
nd
Powerline adapter will make a secured connection to the 1
rd
Powerline adapter for 10 seconds. Release the
st
Powerline adapter for 2 seconds. The power LED will
rd
Powerline adapter for 2 seconds. The Power LED will
rd
Powerline adapter will make a secured connection to your existing
st