Incorrect Operation - Columbus McKinnon Tigrip TWH 30 Instrucciones De Servicio

14
Two-legged lifting gear is only suitable for small plates with low weights, for which sway during
transport can be compensated by hand. When attaching the load lifting attachment, it must be
ensured that the centre of gravity of the load is in the middle between the load lifting
attachments so that no inclined position is caused. In combination with a spreader beam, two
sets of two-legged lifting gear are suitable for universal applications.
Always transport the load slowly, carefully and close to the ground.
Only use crane hooks with a safety latch.
The suspension eye of the load lifting attachment must have sufficient space in the crane hook
and be freely articulating.
In the case of malfunctions, stop using the load lifting attachment immediately.
I O
NCORRECT PERATION
(list not complete)
Do not exceed the rated load capacity (WLL) of the unit.
Only loads within the specified jaw capacity must be picked up. The min. dimensions of the
load must always be complied with in particular for load lifting attachments with a jaw capacity
that does not start with 0.
Any modifications of the load lifting attachment are prohibited.
It is forbidden to use the load lifting attachment for the transportation of persons.
When transporting loads ensure that the load does not swing or come into contact with other
objects.
Only one sheet metal plate or bundle of sheets may be transported at a time with the load
lifting attachment.
It is forbidden to transport single sheets and bundles of sheets which are subject to major
deflection during transport, since the sheets may slip out of the clamp.
©
2016 Columbus McKinnon Industrial Products GmbH