Electric gripper kit – Operating instructions
5 Work and safety instructions
5.1 General
5.2 Mechanical components
12
•
Apprentices should only work with the components and systems under the
supervision of an instructor.
•
Observe the specifications included in the datasheets for the individual
components, and in particular all safety instructions!
•
Wear your personal protective equipment (safety goggles, safety shoes) when
working on the circuits.
•
Switch off the power supply!
–
Switch off both the operating power and the control power before working on
the circuit.
–
Only reach into the setup when it is at a complete standstill.
–
Be aware of potential overtravel times for the actuators.
•
Risk of injury during troubleshooting!
Use a tool such as a screwdriver when actuating mechanical limit switches.
•
Mount all of the components securely onto the slotted profile plate.
•
Make sure limit switches are not actuated from the front.
•
Set all components up in a way that enables easy activation of the switches and
disconnectors.
•
Follow the instructions about positioning the components.
CAUTION
WARNING
CAUTION
© Festo Didactic 8150418