To Reset The Chain Brake; Operation - Husqvarna 120 Mark II Manual Del Usuario

9. The saw chain is correctly tightened as it does
not sag from below the guide bar, but you can
turn it easily by hand.
10. Hold up the guide bar tip and turn the knob
clockwise to tighten it.
• Examine the chain tension frequently after
you assemble a new saw chain and until the
saw chain has been run-in.
• Examine the chain tension regularly. Correct
chain tension results in good cutting
performance and a long life.

To reset the chain brake

If the clutch cover is removed accidentally while the
chain brake is locked, the chain brake must be
WARNING: Read and understand the
safety chapter before you operate the
product.
654 - 002 - 12.04.2018
unlocked so the clutch cover can be assembled
without binding to the clutch drum.
Note: Do not hold the brake band while attempting to
reset it.
1. Align the notches on the bar tool so that they fit
over the brake rotating link.
2. To reset the brake, rotate the link clockwise until
it stops. The front link will be in its downward
rotated position when the chain brake is
unlocked.

OPERATION

CAUTION: The chain brake spring is
under tension. Use care when resetting
the chain brake.
11