jbc PHS-KB Manual De Instrucciones página 6

Safety
It is imperative to follow safety guidelines to protect health and prevent electric
shock, injury, fire or explosions.
- Do not use the units for any purpose other than PCB preheating. Incorrect use may cause fire.
- The power cord must be plugged into approved bases. Be sure that it is properly grounded
before use. When unplugging it, hold the plug, not the wire.
- The temperature of accessible surfaces may remain high after the unit is turned off. Handle with care.
- Do not leave the appliance unattended when it is on.
- Do not cover the ventilation grills. Heat can cause inflamable products to ignite.
- Use a "non residue" classified flux and avoid contact with skin or eyes to prevent irritation.
- Be careful with the fumes produced when soldering.
- Keep your workplace clean and tidy. Wear appropriate protective glasses and gloves when
working to avoid personal harm.
- Utmost care must be taken with liquid tin waste which can cause burns.
- This appliance can be used by children over the age of eight and also persons with reduced
physical, sensory or mental capabilities or lack of experience provided that they have been given
adequate supervision or instruction concerning use of the appliance and understand the hazards
involved. Children must not play with the appliance.
- Maintenance must not be carried out by children unless supervised.
10 10 10
Specifications
IR Preheater Set
PHS-1KB / PHS-2KB / PHS-9KB
- Total weight: 4.9 kg (10.8 lb)
- Ambient Operating Temperature: 10-40ºC (50-104ºF)
PHS-1B 120V. Input 120V 50/60Hz Fuse 8A
PHS-2B 230V. Input 230V 50/60Hz Fuse 4A
PHS-9B 100V. Input 100V 50/60Hz Fuse 8A
- Weight: 2.9 kg (6.4 lb)
- Dimensions (Heater Unit): 173 x 282 x 41 mm
- Maximum Power: 500W
- Heating Area: 65 x 135mm (1 zone) 130 x 135mm (2 zones)
- Temperature Range: 50-250°C (120-482ºF)
- Temperature Measurement: Thermocouple type K
- JBCset temperature profiles: 3 profiles ( 2, 3 or 4 steps)
- User Profiles: 20 (up to 6 steps for each)
- Maximum work time: 600 min or indefinite
PHS-SA
- Weight: 2 kg (4.4 lb)
- Dimensions: Low position 267 x 259 x 75 mm / High position 267 x 259 x 95 mm
- ESD safe connector
Complies with CE standards
ESD protected housing "skin effect"
w w w.jbctools.com
11 11 11