Adjusting The Sound Characteristics; Attenuating The Sound - Sony XR-C5300RX Manual De Instrucciones

Press (DSPL) to change
the displayed items.
Tip
While the ATA function is activated, the display
(TAPE y TUNER) can be changed by pressing
(DSPL).
Changing the operative direction
The operative direction of controls is factory-
set as shown below.
To increase
To decrease
If you need to mount the rotary commander on
the right hand side of the steering column, you
can reverse the operative direction.
Press (SOUND) for two seconds while
pushing the VOL control.
Tip
You can also change the operative direction of
these controls with the unit (see "Changing the
sound and display settings" on page 22).
Adjusting the sound
Press (SOUND) to
characteristics
adjust the volume
and sound menu.
You can adjust the bass, treble, balance, and
fader.
You can store the bass and treble levels
independently for each source.
1
2
Note
Adjust within three seconds after selecting the
item.

Attenuating the sound

To restore the previous volume level, press
(ATT) again.
Tip
When the interface cable of a car telephone is
connected to the ATT lead, the unit decreases the
volume automatically when a telephone call comes
in (Telephone ATT function).
(XR-C5300RX/C5300RV/C5300R/4300RX/4300RV/
4300R only)
Select the item you want to adjust by
pressing (SOUND) repeatedly.
Each time you press (SOUND), the item
changes as follows:
BAS (bass) t TRE (treble) t
BAL (left-right) t FAD (front-rear)
Adjust the selected item by pressing
either side of (SEEK/AMS).
When adjusting with the rotary
commander, press (SOUND) and rotate the
VOL control.
Press (ATT) on the rotary commander or
card remote commander.
"ATT-ON" flashes momentarily.
21