Husky HU80709 Manual Del Operador página 12

 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-866-340-3912 for assistance.
PACKING LIST
Pressure Washer
25 ft. High Pressure Hose
Trigger Handle
Spray Wand
Quick-Connect Nozzle (3)
Soap Blaster™ Nozzle
Injection Hose
Injection Hose Filter
Wheel (2)
Flat Washer (2)
Axle (2)
Hitch Pin (2)
4-Cycle Engine Oil (SAE 30 or SAE 10W30)
Handle
Nozzle Holder with Spring Clip
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Failure to heed this
warning could result in serious personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
ATTACHING THE WHEEL ASSEMBLY
See Figure 2.
 Locate the axle, hitch pins, washers, and wheels. Remove
the hitch pin from the axle.
ASSEMBLY
 Slide the axle through the hole in the center of the
wheel.
 Slide the washer onto the axle.
 Lift the machine and slide the axle into the wheel mount-
ing hole in the machine base.
 Push the hitch pin into the hole on the end of the axle to
secure the wheel assembly.
NOTE: The hitch pin should be pushed into the axle until
the center of the pin rests on top of the axle.
 Repeat with the second wheel.
INSTALLING THE HANDLE
See Figure 3.
 Push and hold the button on the handle as you slide the
handle into the holes in the frame.
NOTE: Before use, pull the handle up until the lock
button snaps through the locking slot to secure the handle
in place.
ATTACHING INJECTION HOSE
See Figure 4.
Before detergent can be used with this machine, the injection
hose must be attached.
 Open the cap from the detergent container.
 From the top of the cap, slide the injection hose through
the hole in the cap.
 Push the injection hose filter onto the end of the injec-
tion hose and pull enough hose through the cap so the
injection hose filter will rest at the bottom of the detergent
container (or detergent bottle).
 Close the cap on the detergent container.
 Push the open end of the clear injection hose securely
over the fitting as shown in figure 4.
NOTE: Keep injection hose away from hot surfaces by push-
ing the hose into the clip in the frame.
ASSEMBLING THE TRIGGER HANDLE
See Figure 5.
 Place the threaded end of the spray wand in the connector
on the end of the trigger handle.
 Turn the connector clockwise until it stops. This
the spray wand in place.
CONNECTING HIGH PRESSURE HOSE TO
TRIGGER HANDLE
See Figure 6.
 Screw the collar on the high pressure hose into the
trigger handle inlet coupler by turning the hose collar
clockwise.
 Pull on the hose to be certain it is properly secured.
8 — English
secures