Hands-Free Function - Hama SNAPDROP Instrucciones De Uso

4.6 Remote release function
• After successfully establishing a Bluetooth
connection, open the camera function on
your terminal device.
• Switch the Hama Snapdrop from Audio
mode to Camera mode by pressing and
holding the camera button (6) until an
acoustic signal confirms that the mode has
been changed.
• Set your device to use the camera on the
front so that you can take a selfie, or use
the camera on the back to take pictures or
record videos normally.
• Press the camera button (6) to trigger the
selected function (selfie, photo, video).
• If you want to listen to music again using
the Hama Snapdrop, switch back to the
Audio mode by pressing and holding the
camera button (6).
6

4.7 Hands-free function

You can use the speaker as a hands-free set
for your mobile phone. For this function,
the mobile phone must be connected to the
speaker via Bluetooth .
• Press the Play/Pause/Mode button >ІІ (4)
once to answer an incoming call.
• Press and hold the Play/Pause/Mode button
>ІІ (4) for about 3 seconds to reject an
incoming call.
• If you would like to end a call, press the
Play/Pause/Mode button >ІІ (4) once
during the call.
Note – Call quality
To increase the call quality, make sure that
you are near the speaker with your mobile
phone during the call.
5. Care and Maintenance
Only clean this product with a slightly damp,
lint-free cloth and do not use aggressive
cleaning agents.