Tabla de contenido
Publicidad
ASSEMBLY INSTRUCTIONS
4. Before tightening the faucet connector to the
water supply, apply a second wrench to the
supply tube fitting. This will prevent the supply
tube from moving or twisting when tightening the
faucet connector. Do not overtighten.
5. Install the soap dispenser:
a. Remove the mounting nut (I) from the
pump flange (H). Insert the pump flange (H)
through the selected hole in the sink.
b. Secure the pump flange (H) to the sink with
the mounting nut (I).
c. From under the sink, screw the bottle (J)
onto the shank of the pump flange (H).
d. Insert the pump (G) down into the pump
flange (H).
OPERATION INSTRUCTIONS
1. After the installation is complete:
a. Remove the aerator from the faucet
(A) with the aerator tool (AA),
unscrewing in a counterclockwise
direction.
b.Turn on the water supply and allow
both hot and cold water to run for at
least one minute each.
c. While the water is running, check for
leaks.
d.
into the faucet (A) using the aerator
tool (AA).
4
5
1
AA
5
G
H
I
J
A
Publicidad
Tabla de contenido
