Cleaning The Appliance; Cleaning The Epilator Head; Cleaning The Shaving Head - Rowenta EP4211 Manual Del Usuario

EP4211_4321_1800117861_1800117861 20/01/10 12:08 Page5

9- CLEANING THE APPLIANCE

• Cleaning the epilator head:

1. Unplug the epilator.
2. Press the release button on the head and remove the epilator head.
3. Rinse the epilator head under cold running water by turning it for 5 to 10 seconds.
1
2

• Cleaning the shaving head

- Stop and unplug the device.
- Remove the protective hood (17).
To do so: hold the appliance firmly and place your fingers on the grip
zone (15) on the shaving head and then pull upwards.
You will remove the protective hood (17) from the blade unit (16).
- Carefully remove the hairs by blowing on
and around the micro grid (13)
Never use the small brush for cleaning the micro grid (13).
DO NOT PRESS ON THE MICRO GRID WHEN PUTTING IT BACK INTO PLACE.
Do not apply alcohol to the body of the appliance in order to avoid damaging
its colours. Do not use a metal or sharp tool.
You can also run the protective hood (17) and the blade block (16)
under running cold water to remove all the hair. Shake the parts well
and then dry them using a towel without pressing down on the
micro grid before reassembling them.
- Put the protective hood (17) back on the blade unit (16).
You will hear a click.
4. Shake the epilator head vigorously
and dry it with a towel before fitting it
to the epilator again.
You can also use the small cleaning brush
supplied.
5