Maintenance And Cleaning; Cleaning The Epilator Head - Rowenta LOVELY EP4760D0 Manual De Instrucciones

NOT EP4760F4 032052
- If you want a hair length of
approximately 9 mm, use the largest
comb.
- If you want a hair length of
approximately 3 mm, use the smallest
comb.
- If you want a hair length of
approximately 6 mm, use the medium-
sized comb.
Slide the comb into the two grooves on
the trimmer head (fig.12), then set the
6 • For a neat bikini outline
If you want a closer shave, use the
bikini line trimmer head without the
comb:
Set the switch to 0 and plug in the
appliance.
Push to remove the comb (fig.14).
Next, switch the appliance on using the
on/off switch.
Hold the appliance upright and move it

MAINTENANCE AND CLEANING

7 • Cleaning the epilator head
Stop the appliance and unplug it.
Press the release button on the head
and remove the epilator head (fig.16).
Rinse the epilator head under cold run-
ning water by turning it for 5 to 10
seconds (fig.18).
Shake the epilator head vigorously
8 • Cleaning the sensitive area accessory
Clean the accessory with alcohol and rinse it under running water (fig.20).
22/03/07 10:55
switch to 1.
Hold the appliance upright so that you
can see the appliance name, and move
it slowly against the hair (fig.13).
IMPORTANT
If your skin becomes irritated, apply
some talc after use.
slowly against the hair (fig.15).
IMPORTANT
For greater effectiveness, pull hair
outward with the other hand to
make it stand out. This will give you
a more precise shave with little
irritation.
(fig.19)
fitting it to the epilator again.
IMPORTANT
You can also use the small cleaning
brush supplied (fig.17).
Page 15
and dry it with a towel before
GB