Assembling The Mast To The Base; Unfolding The Spreader Bar - Invacare Birdie EVO Manual Del Usuario

Invacare® Birdie® EVO
1. Lock both rear castors B. Remove the locking pin A.
2. Raise the mast assembly C to an upright position by
stepping with one foot on the leg D and pulling the push
bar E upwards until the safety catch F snaps in place.
3.
Reinstall the locking pin A through the mast G and
base H. Ensure that the locking pin is correctly inserted.

4.3.2 Assembling the mast to the base

(fixed mast only)
WARNING!
Risk of injury or Damage
The maximum safe working load stated on the
boom and on the base must be the same.
– Always compare the maximum safe working
load values stated on the base and on the
boom.
10
1.
Lock both rear castors B and rotate the hand screws
anti-clockwise A to remove them from the base
2.
With the boom pointing in forward direction, lower the
mast C into the support of base D and reinstall the
hand screws A to fix the mast C to the base.

4.4 Unfolding the spreader bar

1.
Open the fastener A and remove the band B from the
clamping buckle.
1650023-D