Installing The Actuator To The Boom; Installing The Lever For Manual Leg Spreader; Resetting The Service Indicator - Invacare Birdie EVO Manual Del Usuario

2.
Push and hold the boom C towards the mast D and
fold down the spreader bar holder E.
3.
Fold down the spreader bar F and fold up the spreader
bar holder E.
4.
Wrap the band B around the back of the mast, insert it
into the clamping buckle and close the fastener A.

4.5 Installing the actuator to the boom

1650023-D
1. Release the D-clip and remove the pin A from actuator
B.
2. Remove the actuator B from the bracket on the mast
and fit it to the boom mounting bracket C.
3.
Align the holes and reinstall the pin A. Make sure that
the pin is completely inserted and secure it with the
D-clip.
IMPORTANT
Due to higher loads, Birdie® EVO XPLUS requires
a longer pin.
– Only use Birdie® EVO XPLUS with the longer
pin, indicated by a black D-Clip.
4.6 Installing the lever for manual leg
spreader
2 x 13 mm wrench
1. Insert the bolt A from below into the lower hole of the
bracket B and fix it with the nut C.
2. Insert the threaded end of lever D into the upper hole
of bracket B onto the fixed bolt A.
3. Turn the lever D clockwise to screw it onto the bolt.

4.7 Resetting the service indicator

(CBJ Care control unit only)
IMPORTANT!
If the service light is flashing yellow during daily
usage or after a reassembly, the lift requires
service.
– Contact your Invacare provider for service.
After the initial assembly of the lift, the service indicator
needs to be reset before using the lift.
To perform an initial reset of the service indicator:
Setup
11