Product Description; Cleaning And Maintenance - Concept RK4170 Manual Del Usuario

EN

PRODUCT DESCRIPTION

1 Handle for opening the lid
2 Lid
3 Current temperature indication
4 Temperature setting / Set temperature indication
5 Base with power cord
6 Handle
7 Temperature control +/- buttons
8 ON/OFF button
1
2
3
4
NOTICE:
Before first use, we recommend boiling the maximum volume of water at least 3 times and pour it out. Afterwards, the
kettle is ready for use.
The kettle may only be used with the supplied base.
36
7 8
6
5
RK4170
OPERATING INSTRUCTIONS
1. Remove the kettle from the base, open the lid and fill it with cold water (the water level must be within the MIN-
MAX watermarks inside of the kettle).
2. Place the kettle on the base. The electrical contacts will connect automatically. Thanks to the central connector
design, the kettle can turn around 360° and can be placed on the base from any side.
3. Connect the base to the mains. You will hear a sound signal, all the indicators will light up for a moment and then
the current temperature will remain lit. The kettle is ready for use.
4. By pressing the ON/FF button, the kettle automatically boils water to 100 °C.
5. If you want to select one of the pre-set temperatures (40, 60, 80 or 90 °C), press the Temperature control +/- button
repeatedly until the desired temperature lights up on the display. Press the ON/OFF button, the Temperature setting
indicator will flash. Then press the ON/OFF button again to confirm the desired temperature, the Set temperature
will light up. From now on, the kettle will boil water to the set temperature.
6. The kettle will automatically switch off after reaching a boiling point or the set temperature.
7. Remove the kettle from the base and use the water.
8. If you need to reheat the water that has just been boiled, wait approximately 30 second before switching on the
kettle again.
Note:
• If you do not confirm the set temperature again (i.e. the indicator does not remain lit, but it is flashing), the kettle
will boil water to 100 °C.
• If you have not set any temperature, you can interrupt the heating process at any time by pressing the ON/OFF
button.
• If you have set a temperature and you want to interrupt the heating process, press the Temperature control +/-
button repeatedly until 0 is reached (no indication on the display) and then press the ON/OFF button.
• A few drops of water appearing on the base of the kettle after use is not a sign of a defect. It is a small amount of
condensed water, which deactivates the kettle thermostat.

CLEANING AND MAINTENANCE

Caution!
Before each cleaning of the appliance, unplug the power cord from the electrical outlet! Make sure the appliance has
cooled before handling it!
To clean the surface of the appliance, use only a damp cloth, no detergents or hard objects, as they can damage the
surface of the appliance!
Never clean the appliance under running water, do not rinse it or immerse it in water!
Descaling
During normal use, deposition of impurities from water occurs. Use commercially available descaling agents to clean
them (follow the manufacturer's instructions).
Note: Remove the deposits regularly, approximately once a week, depending on the water hardness and frequency of
use. The deposits significantly reduce the heating capacity and the lifespan of the appliance.
RK4170
EN
37