Tabla de contenido
Publicidad
EN
EN
• Do not switch the unit on without water. If an empty kettle is turned on, the safety fuse will deactivate it
automatically. Let the kettle cool, then fill it with cold water and you may use it again.
• Extra care should be taken while opening the lid when refilling the hot kettle with water.
• Take precautions to avoid scalding with hot water while handling the kettle. Always hold the kettle by the
handle, as the vessel can be hot and may burn you.
• Pour the hot water slowly – excessive tilting may cause the water to flow through the lid – RISK OF
SCALDING!
• Do not use abrasive or chemically aggressive substances to clean the appliance.
• Do not use the unit if it does not operate properly, or if it has been dropped, damaged or exposed to any
liquids. Have the appliance tested and repaired by an authorised service centre.
• Never use the appliance if the supply cable or plug has been damaged; have the defect repaired immedi-
ately by an authorised service centre.
• The appliance is not designed for outdoor use.
• The appliance is intended for household use only, not for commercial use.
• Do not immerse the supply cable, the plug, or the appliance itself in water or any other liquid.
• Never repair the appliance yourself. Instead, contact an authorised service centre for repair.
• This appliance may be used by children 8 years of age and older and by persons with physical or mental
impairments or by inexperienced persons if they are properly supervised or have been informed about
how to use of the product in a safe manner and understand the potential dangers. Children must not play
with the appliance. This appliance may be cleaned by children 8 years of age and older if they are properly
supervised. Keep this appliance and the power cord out of reach of children younger than 8 years of age.
Failure to follow the manufacturer's instructions may lead to refusal of warranty repair.
PRODUCT DESCRIPTION
1.
Lid
2.
Power indicator
3.
Handle
4.
Switch
5.
Supply cable base
5
24
24
CAUTION
Prior to first use, we recommend boiling the maximum volume of water in the kettle at least 3 times, then
pouring it out. The kettle is then ready for operation.
The kettle may only be used with the supplied base.
OPERATING INSTRUCTIONS
1. Remove the kettle from the base (5), open the lid (1), and fill the appliance
2.
3.
4.
5.
6.
7.
1
Note: It is not a sign of a defect when a small amount of water droplets
appear on the kettle base (5). It is a small amount of condensed steam,
3
which deactivates the kettle thermostat.
CLEANING AND MAINTENANCE
Warning!
• Prior to each cleaning operation disconnect the lead-in cable of the
• Prior to start any handling operation, make sure that the appliance is
2
• Use only a wet rag for cleaning surface of the appliance, do not use any cleansers or hard things which
4
• Never clean the appliance under running water, never flush it and never immerse the appliance into
Scale removal
During common use water impurities are deposited. Use commercially available agents for scale removal
(observe manufacturer's instructions).
RK 00 15
RK0050
RK 00 15
RK0050
with cold water within the permitted maximum only (MAX marking on
the cover of steam pipe inside the kettle). If the water level in the kettle is
under the recommended minimum (0,3 l), the kettle will keep overheating
and turning off prematurely.
Note: Make sure that the lid (1) is closed properly, otherwise the kettle can not turn off automatically
Place the kettle on the base (5); electric contacts will get connected automatically. Thanks to the central
connector design, the kettle can turn around 360° and be put on the base from any side.
Connect the base to the mains.
Turn the kettle on by pressing the switch (4).
A control light on the switch (2) signals the kettle is in operation. The kettle lid (1) must be properly closed
when water is being heated.
WARNING!
Do not open the lid during heating or immediately after heating is completed. Hot steam could scald you!
After the boiling point has been reached, the kettle will turn off automatically, and the operating light
will go out. Water heating can be terminated prematurely by moving the switch (4) to the off position.
Remove the kettle from the base (5) and use the hot water.
If you want to reheat the water you have just finished boiling, wait for ap-
proximately 30 seconds before reactivating the switch (4).
appliance from el. socket!
cooled down!
could damage the surface!
water!
EN
EN
25
25
Publicidad
Tabla de contenido
