Troubleshooting And Maintenance - Rapid PMP171 Manual De Instrucciones - Traducción Del Original

cannot be guaranteed, it is there-
fore recommend that 2 to 5 drops
(depending on the loading of the
tool) of the recommended oil (see
technical specifications) should be
added via the air inlet of the tool,
or an oiler attached directly to the
fastener driving tool.
TROUBLESHOOTING
AND MAINTENANCE
If a pin jam occurs, disconnect tool
from air supply. (Figure 3) Release
magazine and slide the rail back.
(Figure 8) Remove jammed fasten-
ers.
Or release the two screws of the
front cover and pull it out. (Figure
9) Remove the jammed projectile.
(Figure 10) Replace the front cover
and tight the screws.
MAINTENANCE
While tool is disconnected from
air supply, make daily inspection
to ensure free movement of safety
yoke and trigger. (Figure 3) All
screws should be kept tight. loose
screws result in unsafe operation
and parts breakage. Squirt oil lightly
with 2 or 3 oil drops into the air inlet.
Only use supplied oil for the tool or
recommended oil in the technical
specifications. Keep the tool clean.
Wipe it regularly with a dry cloth,
and inspect for wear. Lubricate the
sliding parts of the magazine oc-
casionally to prevent wear. Do not
use flammable cleaning solutions.
do not soak and use solvent, such
solutions may damage O-rings and
other sensitive tool parts. Use clean,
dry air. Preferably use a processing
unit of compressed air upstream of
the connection of the tool. Repairs
10
other than those described here
should be performed only by trained,
qualified personnel or by Rapid
after-sales-service.
EXPLODED VIEW AND SPARE
PARTS KITS
KiT no. Description
Kit A Head valve, cylinder and piston set 5001346
Kit B Safety and trigger set
Kit C Magazine set
(Figure 12)
Kit Art no.
5001347
5001348